Out of Stock
Thumbnail 1
Thumbnail 2
Thumbnail 3
Thumbnail 4
Thumbnail 5
Thumbnail 6
Thumbnail 7
Thumbnail 8

BERGEN Solar Powered LCD Welding Helmet with Auto Darkening Filter CE Approved

REF: 4790

UPC: 5055553937032

£37.15
GBP
37.1537.15

Description

BERGEN Solar Powered LCD Welding Helmet with Auto Darkening Filter CE Approved - NEW

BERGEN TOOLS, need we say more.

This auto darkening helmet is your essential tool when it comes to ARC, MIG and TIG welding.

It's auto darkening feature is powered by 2 AAA batteries and solar cells so you'll rarely need to change your batteries.

It's large view area allows you to see clearly what your welding and the auto darkening response time is an incredible 0.04ms.

The shade state can be adjusted continuously and all UV and IR protection come into compliance to safety standards; CE: EN 379:2003; EN 169:2002; EN 175:1997

Introduction

The welding helmet is delivered ready for use. For your protection and to ensure that your LCD VISION auto darkening welding helmet functions properly, read these instructions carefully and consult with a qualified instructor prior to operation.

Before Welding

Check whether the front cover lens and the front frame are inserted and fixed in place. Use the correct level of protection for your welding process. Please refer to the following chart to help your choice.

Preparations for Use

The LCD VISION auto-darkening welding helmet switches light to dark state when a welding arc is struck. The auto-darkening welding helmet switches back to the light state when the arc stops.

Safe Practice

The auto-darkening welding helmet is suitable for use with virtually all welding processes except Oxy-Acetylene welding, laser welding and gas. However, it is not recommended to use this type of filter when the arc is glimmer or just incandescent. In this case, it is necessary to do a try out before use

Standard protective plates must be installed on both the inside and the outside surfaces of the filter. Failure to use protective plates may constitute a safety hazard or result in irreparable damage to the filter.

Maintenance

Carefully inspect the LCD VISION auto-darkening welding helmet. Cracked, pitted or scratched filter glass or cover plate reduces vision and seriously reduces the level of protection. Such damaged components must be replaced immediately to avoid risk of serious eye and face injuries. Clean the lens with a lint free tissue. Do not use solvent.

Note: we have spare lenses in our store to replace broken, scratched or worn lenses.

Specification


o Use with ARC, MIG and TIG welding
o Full face coverage with ratcheting headband
o Cartridge size: 110x90x9mm (4.33"x3.55"x0.35")
o Viewing field: 90x45mm (3.55"x1.78")
o Shade number: Light state: DIN 4, Dark state: DIN 9 - 13
o Shade control: Outer adjustment
o Sensitivity control: internal adjustment
o Switching time: Light-Dark: 1/25,000sec (0.04ms)
o Recovery time: Dark-Light: 0.4sec
o UV-IR protection: up to shade DIN 16 at all time
o Power Supply: Solar cells + replaceable 2xAAA batteries (not included)
o Lens power control: Manual-on, Auto-off after 15 minutes idle time
o Operating temperature: -5C to +55C (23F to 131F)
o Standards: CE: EN 379:2003; EN 169:2002; EN 175:1997
o Net weight: 440g (0.97lb)